Honda Key Fob Lock Works but Unlock Does Not

The complaint “honda key fob lock works unlock doesn’t” is easy to misread as a dead battery. The fob locks the car and will not unlock it. A dead coin cell usually takes the whole fob down together: short range on every button, or no light at all. One live button means the transmitter still has enough power to talk to the car. The unlock circuit, the rubber pad, or the car’s own lock logic is the more precise suspect.

Still change the cell. It is the only step that is both cheap and shared with every other fault on this site. Use the number stamped on the cell you remove. Then test unlock from the same spot where lock just worked. If unlock returns, the cell was marginal and unlock, which people press more often, was the first button to feel it.

Start with the stamped code

Battery to buy the same cell already in the fob, usually CR2032 or CR1616
Fob you are likely holding a fob whose lock button still reaches the car

Problems that look like a dead battery

If unlock is still dead and lock is still fine, look at the rubber. Unlock is the button thumbs hit, and it is the one that tears or sinks. Open the shell only after the new cell is in, so you are not judging a flat battery. Check that the little conductive pill under the unlock symbol is still stuck to the rubber and still lands on the board. A pill that has fallen off, or a board track that has cracked under that switch, will ignore that button forever while lock keeps working.

The car can also refuse unlock while it thinks a door is open, or while the driver’s door was locked with the metal key in a way that sets a double-lock on some markets. Try unlock from the driver’s window switch before you condemn the fob. If the switch inside the car unlocks the doors, the latches are fine and you are back to the fob.

Why the car may still ignore the fob

Do not program a second fob because one button failed. Programming does not rebuild a pad. Do not soak the shell to “clean” it. If you already spilled a drink, the water-damage path is a different problem, and a new cell in a wet board will corrode the copper you still have.

A locksmith can replace the rubber or the shell and keep the original board, which is cheaper than a dealer key when the car still recognizes the fob at the start button. Bring the fob. The car does not need to come unless the interior switch will not unlock the doors either.

More Honda battery guides

Quick answers

Why does my Honda fob lock but not unlock?

The transmitter still works. Unlock’s button pad, a marginal cell, or a door-lock setting is the usual cause. A fully dead battery tends to kill every button.

Will a new battery fix one dead button?

Sometimes, if the cell was weak. If lock still works from the curb and unlock does not, inspect the unlock pad next.

Do I need a new Honda key for one button?

Not yet. A shell or a rubber is the repair when the car still knows the fob.

Honda is a trademark of Honda Motor Co., Ltd. Honda Key Fob Battery is an independent guide and is not affiliated with, endorsed by, or sponsored by Honda. The code printed on the cell already in your fob overrides any chart. A fob bought later, or a car sold in another country, can use a different shell.

Independent guide. Honda is a trademark of Honda Motor Co., Ltd. This site is not affiliated with, endorsed by, or sponsored by Honda. The code printed on the cell in your fob overrides any chart.

Scroll to Top