CR2032 vs CR2025 for a Honda Key Fob

If you are searching for “cr2032 vs cr2025 honda key fob”, start with the stamped code on the coin cell already inside the fob. That stamp beats a generic year chart.

CR2032 vs CR2025 for a Honda key fob is a diameter trap. Both cells are about 20 millimeters across, so both look right when you set them on the counter. The last two digits are the thickness in tenths of a millimeter. CR2032 is 3.2 mm. CR2025 is 2.5 mm. That 0.7 mm is the entire difference between a contact that presses and a contact that barely meets the cell.

Most Honda smart keys of the last decade, the push-button cars, are built for the thicker CR2032. A smaller group of older compact remotes were built for CR2025. You do not choose by era from memory. You read the cell that came out of the fob in your hand.

Battery size and what to buy

Battery to buy CR2032 for most smart fobs; CR2025 only if that number is stamped on the old cell
Fob you are likely holding a cup built for one thickness, not both

Replacing the cell without damage

A CR2025 dropped into a CR2032 cup sits low. The fob may work if you press the shell together with your fingers and quit when you let go. People then buy a second CR2025, and a third, and announce that Honda fobs eat batteries. The cup is fine. The cell is short.

A CR2032 forced into a remote that was designed for CR2025 is worse. The shell will not close, or it closes by bending the contact finger. The next correct cell then rattles. If you have already done this, gently lift the finger back toward where it stood. Do not pry it past vertical.

Neither cell is rechargeable. An LIR2032 is a different product that happens to share the diameter, and it does not belong in a Honda fob.

If range is still poor after the swap

Take the old cell to the store if you can. Match the six characters, not the phrase “fits Honda.” A listing that offers CR2032/CR2025 as if they were a set is the listing to close. Buy one name-brand cell of the right number. Fit the plus side to the molded mark. Close the shell until the seam is even, and test from the curb.

If your old cell is gone and the cup is a smart-key cup with an emergency key in the shell, CR2032 is the usual purchase, and you confirm it by how the shell closes. A shell that will not shut without force means stop, not push harder.

CR2032, CR2025, and CR1616 drawn at relative diameter CR2032 20 mm · 3.2 mm CR2025 20 mm · 2.5 mm CR1616 16 mm · 1.6 mm
Same drawing scale: CR2032 and CR2025 share a 20 mm diameter and do not share a thickness. CR1616 is the smaller disc.

Continue with these guides

Short FAQ

Can I use a CR2025 instead of a CR2032 in a Honda fob?

No. The CR2025 is thinner. Range becomes intermittent or disappears even though the cell is new.

Can I use a CR2032 instead of a CR2025?

No. It is too thick for a cup built for CR2025 and can bend the contact.

Which one do most Honda smart keys use?

CR2032. Older small remotes sometimes use CR2025. The stamp on your cell is the decision.

Honda is a trademark of Honda Motor Co., Ltd. Honda Key Fob Battery is an independent guide and is not affiliated with, endorsed by, or sponsored by Honda. The code printed on the cell already in your fob overrides any chart. A fob bought later, or a car sold in another country, can use a different shell.

Independent guide. Honda is a trademark of Honda Motor Co., Ltd. This site is not affiliated with, endorsed by, or sponsored by Honda. The code printed on the cell in your fob overrides any chart.

Scroll to Top